Only 2 left in stock
close
Avetek #BSI-106 Insta-Cure+ CA, Medium Super Glue 1/2oz-14g
5-10 Second Drying Time
Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ ™ should also be used. To prevent premature curing, don’t spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.
Works Best On:
Balsa Wood
Soft Wood
Works Good On:
Hard Wood
Glass & Metal
Fiberglass
Ceramics
Hard Plastics
Rubber
Laminating
Water-Resistant
Reinforcing
